Product Specifications

• ZYNQ XC7Z020-1CLG400C

  • 650MHz dual-core Cortex-A9 processor

  • DDR3 memory controller with 8 DMA channels and

  4 High Performance AXI3 Slave ports

  • High-bandwidth peripheral controllers: 1G Ethernet, USB 2.0, SDIO

  • Low-bandwidth peripheral controller:

  SPI, UART, CAN, I2C

  • Programmable from JTAG, Quad-SPI flash,

  and MicroSD card

  • Programmable logic equivalent to Artix-7 FPGA

  • 13,300 logic slices, each with four 6-input LUTs

  and 8 flip-flops

  • 630 KB of fast block RAM

  • 4 clock management tiles, each with a phase

  locked loop (PLL) and mixed-mode clock

  manager (MMCM)

  • 220 DSP slices

  • On-chip analog-to-digital converter (XADC)

• Memory

  • 512MB DDR3 with 16-bit bus @ 1050Mbps

  • 16MB Quad-SPI Flash with factory programmed

  48-bit globally unique EUI-48/64™ compatible

  identifier

  • MicroSD slot

• Power

  • Powered from USB or 7V-15V external power source

• USB and Ethernet

  • Gigabit Ethernet PHY

  • Micro USB-JTAG Programming circuitry

  • Micro USB-UART bridge

  • USB 2.0 OTG PHY (supports host only)

• Audio and Video

  • HDMI sink port (input)

  • HDMI source port (output)

  • I2S interface with 24bit DAC with 3.5mm TRRS jack

  • Line-in with 3.5mm jack

• Switches, Push-buttons and LEDs

  • 4 push-buttons

  • 2 slide switches

  • 4 LEDs

  • 2 RGB LEDs

• Expansion Connectors

  • Two standard Pmod ports

  • 16 Total FPGA I/O (8 shared pins with Raspberry Pi connector)

  • Arduino Shield connector

  • 24 Total FPGA I/O

  • 6 Single-ended 0-3.3V Analog inputs to XADC

  • Raspberry Pi connector

  • 28 Total FPGA I/O (8 shared pins with Pmod A port)