ZYNQ XC7Z020-1CLG400C
• 650MHz dual-core Cortex-A9 processor
• DDR3 memory controller with 8 DMA channels and
4 High Performance AXI3 Slave ports
• High-bandwidth peripheral controllers: 1G Ethernet, USB 2.0, SDIO
• Low-bandwidth peripheral controller:
SPI, UART, CAN, I2C
• Programmable from JTAG, Quad-SPI flash,
and MicroSD card
• Programmable logic equivalent to Artix-7 FPGA
• 13,300 logic slices, each with four 6-input LUTs
and 8 flip-flops
• 630 KB of fast block RAM
• 4 clock management tiles, each with a phase
locked loop (PLL) and mixed-mode clock
manager (MMCM)
• 220 DSP slices
• On-chip analog-to-digital converter (XADC)
Memory
• 512MB DDR3 with 16-bit bus @ 1050Mbps
• 16MB Quad-SPI Flash with factory programmed
48-bit globally unique EUI-48/64™ compatible
identifier
• MicroSD slot
Power
• Powered from USB or 7V-15V external power source
USB and Ethernet
• Gigabit Ethernet PHY
• Micro USB-JTAG Programming circuitry
• Micro USB-UART bridge
• USB 2.0 OTG PHY (supports host only)
Audio and Video
• HDMI sink port (input)
• HDMI source port (output)
• I2S interface with 24bit DAC with 3.5mm TRRS jack
• Line-in with 3.5mm jack
Switches, Push-buttons and LEDs
• 4 push-buttons
• 2 slide switches
• 4 LEDs
• 2 RGB LEDs
Expansion Connectors
• Two standard Pmod ports
• 16 Total FPGA I/O (8 shared pins with Raspberry Pi connector)
• Arduino Shield connector
• 24 Total FPGA I/O
• 6 Single-ended 0-3.3V Analog inputs to XADC
• Raspberry Pi connector
• 28 Total FPGA I/O (8 shared pins with Pmod A port)